Optimalisasi Intensitas Cahaya pada Luas Permukaan Solar Cell

Hilmansyah Hilmansyah, Ramli Ramli

Abstract


Abstract

Optimization of power at the output of the solar cell by Surface, Intensity and Wavelength of Light to determine the effect of light intensity, the surface area of the solar cell, and the wavelength of the light filter on the output power generated by the solar cell. Can be used two Solar-cell, each of which has a size of 5 cm x 2.4 cm and 5 cm x 5 cm. With an input voltage of 1.8 V 2.00 V and 2.4 V so as to produce different light intensities. solar cell mounted light filters of red, yellow and blue because it shows that, for all kinds of filters and diesel obtained value of the output power increases. This is due to the greater value given input voltage in the circuit.

 

Keywords : solar-cell output power (output), light intensity

 

 

                                                                                Abstrak

Optimalisasi daya pada keluaran pada solar-cell oleh Luas Permukaan, Intensitas dan Panjang Gelombang Cahaya untuk mengetahui pengaruh intensitas cahaya, luas permukaan solar cell, dan panjang gelombang filter cahaya terhadap daya keluaran yang dihasilkan oleh solar cell. Dapat di gunakan dua buah Solar-cell yang masing-masing memiliki ukuran 5 cm x 2,4 cm dan 5 cm x 5 cm. Dengan tegangan input sebesar 1,8 V 2,00 V dan 2,4 V sehingga menghasilkan intensitas cahaya berbeda-beda. solar cell dipasang filter cahaya merah, kuning dan biru oleh karena hal tersebut diperoleh bahwa untuk semua jenis filter dan jenis solar diperoleh nilai daya keluaran yang semakin besar. Hal ini disebabkan karena semakin besar nilai tegangan input yang diberikan dalam rangkaian.

Kata kunci: solar-cell daya keluaran, intensitas cahaya


Keywords


solar-cell output power (output), light intensity

Full Text:

PDF

References


M. A. Green, "Limits on the open- circuit voltage and efficiency of silicon solar cells imposed by intrinsic Auger processes", IEEE Trans. Electron Devices, vol. 31, no. 5, pp. 671-678, May 1984.

M. J. McCann, K. R. Catchpole, K. J. Weber, A. W. Blakers, "A review of thin-film crystalline silicon for solar cell applications. Part 1: native substrates", Solar Energy Mater. Solar Cells, vol. 68, pp. 135-171, 2001.

G. P. Willeke, "Thin crystalline silicon solar cells", Solar Energy Mater. Solar Cells, vol. 72, pp. 191-200, 2002.

X. F. Brun, S. N. Melkote, "Analysis of stresses and breakage of crystalline silicon wafers during handling and transport", Solar Energy Mater. Solar Cells, vol. 93, pp. 1238-1247, 2009.

A. Schneider, C. Gernards, P. Fath, E. Bucher, R. J. S. Young, J. A. Raby, A. F. Carroll, "Bow reducing factors for thin screenprinted mc-Si solar cells with Al BSF", Proc. 29th IEEE Photovoltaic Spec. Conf., pp. 336-339, 2002.

T. Dullweber, S. Gatz, H. Hannebauer, T. Falcon, R. Hesse, J. Schmidt, R. Brendel, "Towards 20% efficient large-area screen-printed rear-passivated silicon solar cells", Progress Photovoltaics: Res. Appl., vol. 20, no. 6, pp. 630638, 2011.

G. Dingemans, W. M. M. Kessels, " Status and prospects of Al $_{2}$ O $_{3}$ -based surface passivation schemes for silicon solar cells ", J. Vacuum Sci. Technol. A: Vacuum Surfaces Films, vol. 30, pp. 040802-1-040802-27, 2012.




DOI: https://doi.org/10.32487/jtt.v5i1.217

Refbacks

  • There are currently no refbacks.


JTT (Jurnal Teknologi Terpadu) has been indexed by:

 

 

 

 

 

 

 

 

 

Web Analytics

JTT Visitor Stats