Perbandingan Variasi Bahan Insulasi terhadap Temperatur di dalam Ruang Box Panel Listrik Akibat Terpapar Sinar Matahari
Abstract
This Studies, we conducted experiments on several insulation materials in outdoor electrical panel boxes to determine the recommended materials for reducing the temperature produced by heat generated due to hot sunlight. The insulation materials used include Styrofoam, Plywood and GRC. The experiment carried out was by exposing the insulated panel box to sunlight. The results of the experiments carried out showed an increase in temperature of up to 40.10C for standard box panels without insulation, 33.880C for box panels with Styrofoam insulation, 36.780C for Plywood insulation and 36.050C for GRC insulation.
From the experimental results, panel boxes without insulation experienced a very high increase, so that the potential could cause damage to components inside the panel box more quickly. Meanwhile, the box panels that are most stable in maintaining temperature are those that use Styrofoam insulation. Based on these results, Styrofoam material is highly recommended to be used as insulation material for electrical panel boxes
Keywords
Full Text:
PDFReferences
M. Abrori, S. Sugiyanto, and T. F. Niyartama, “Pemanfaatan Solar Cell Sebagai Sumber Energi Alternatif dan Media Pembelajaran Praktikum Siswa Di Pondok Pesantren ‘Nurul Iman’ Sorogenen Timbulharjo, Sewon, Bantul, Yogyakarta Menuju Pondok Mandiri Energi,” J. Bakti Saintek J. Pengabdi. Masy. Bid. Sains dan Teknol., vol. 1, no. 1, p. 17, 2017, doi: 10.14421/jbs.1131.
F. I. Pasaribu and M. Reza, “Rancang Bangun Charging Station Berbasis Arduino Menggunakan Solar Cell 50 WP,” R E L E (Rekayasa Elektr. dan Energi) J. Tek. Elektro, vol. 3, no. 2, pp. 46–55, 2021.
G. Ngurah et al., “Kajian Energi Surya Untuk Pembangkit Tenaga Listrik,” vol. 4, no. 1, pp. 29–33, 2005.
M. Ervin and Jamaaluddin, “Pemanfaatan Solar Cell Sebagai Alternatif Energi Listrik Skala Rumah Tangga,” Mesin Mesin List., 2020, [Online]. Available: http://eprints.umsida.ac.id/7230/
E. Radziemska, “The effect of temperature on the power drop in crystalline silicon solar cells,” Renew. Energy, vol. 28, no. 1, pp. 1–12, 2003, doi: https://doi.org/10.1016/S0960-1481(02)00015-0.
T. Haryanto, “Perancangan Energi Terbarukan Solar Panel Untuk Essential Load Dengan Sistem Switch,” J. Tek. Mesin, vol. 10, no. 1, p. 43, 2021, doi: 10.22441/jtm.v10i1.4779.
J. H. Riko, “Pembangkit Listrik Tenaga Surya (PLTS) Energi Terbarukan,” Academia.edu, vol. 06, no. 02, pp. 136–142, 2014, [Online]. Available: http://www.academia.edu/9106342/Pembangkit_Listrik_Tenaga_Surya_PLTS_Energi_Terbarukan
E. P. Aji, P. Wibowo, and J. Windarta, “Kinerja Pembangkit Listrik Tenaga Surya (PLTS) dengan Sistem On Grid di BPR BKK Mandiraja Cabang Wanayasa Kabupaten Banjarnegara,” J. Energi Baru dan Terbarukan, vol. 3, no. 1, pp. 15–27, 2022, doi: 10.14710/jebt.2022.13158.
E. Supriyadi, “Energi Surya,” Cakrawala Pendidikan, vol. No. Edisi. pp. 22–27, 1989.
R. Hasrul, “Sistem Pendinginan Aktif Versus Pasif Di Meningkatkan Output Panel Surya,” J. Sain, Energi, Teknol. Ind., vol. 5, no. 2, pp. 79–87, 2021, [Online]. Available: https://journal.unilak.ac.id/index.php/SainETIn/index
Y. Yamato and B. B. Rijadi, “Analisis Kebutuhan Modul Surya Dan Baterai Pada Sistem Penerangan Jalan Umum (PJU),” J. Elektro Tek., vol. 1, no. 1, pp. 30–38, 2022, [Online]. Available: https://journal.unpak.ac.id/index.php/JET/article/view/4819
C. G. Popovici, S. V. Hudişteanu, T. D. Mateescu, and N.-C. Cherecheş, “Efficiency Improvement of Photovoltaic Panels by Using Air Cooled Heat Sinks,” Energy Procedia, vol. 85, pp. 425–432, 2016, doi: http://dx.doi.org/10.1016/j.egypro.2015.12.223.
DOI: https://doi.org/10.32487/jtt.v12i2.2270
Refbacks
- There are currently no refbacks.
JTT (Jurnal Teknologi Terpadu) has been indexed by:
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
