Simulasi Lampu Lalu Lintas Simpang Tiga Balikpapan Permai berbasis PLC OMRON CP1E-N30SDR-A

Riza Hadi Saputra, Ain Sahara, Melinda Greshela

Abstract


Today on the highway, especially on crossing roads, motor vehicle users are increasing, both motorbike and car drivers. Not only that, it can be seen from the number that has increased greatly every day. This situation requires the existence of a time setting, whose purpose is nothing but to reduce congestion to the risk of accidents. Therefore, in this study, a traffic light simulation is controlled by OMRON CP1E-N30SDR-A PLC. Traffic light simulation at the three intersections based on PLC OMRON CP1E-N30SDR-A has been made a traffic light control prototype to set the timing of traffic lights at the three intersections based on OMRON CP1E-N30SDR-A PLC. The method used for this research is observation, looking for references about sending data at traffic lights and can be processed on PLC systems. Observations were carried out directly at the place of data collection, namely at Simpang 3 Balikpapan Permai. Programming used to instruct traffic light simulations is to use a ladder diagram programming language created using CX-Programmer software. The purpose of this study is to make a traffic light system in the form of a simulation or prototype that has timing from intersection 3 of Balikpapan Permai. In traffic light simulations, timers are needed to synchronize between available intersections, namely 3 intersections. This is so that the vehicle that passes from one intersection where the traffic light conditions at that time is a green light, then the vehicle no longer waits at the next intersection. The signal is sent from one intersection to another as an indicator so that the intersection can automatically adjust the timing of traffic lights.

Keywords


Traffic Light Simulation, CX-Programmer, PLC OMRON CP1E-N30SDR-A

Full Text:

PDF

References


Y. Irnaldi, A. Apwiddhal, and L. Utama, “KAJIAN KINERJA PERSIMPANGAN TIDAK BERSINYAL STUDI KASUS SIMPANG TIGA PARAK LAWEH BANUARAN KOTA PADANG,” Abstr. Undergrad. Res. Fac. Civ. Plan. Eng. Bung Hatta Univ., vol. 1, no. 1, pp. 1–12, 2015.

R. Firmansyah, F. Baskoro, and B. R. Rynaldo, “Perancangan dan Simulasi Sistem Lampu Lalu Lintas 4 Arah dengan Menggunakan Programmable logic Controller Omron CP1E dengan Tampilan Cx,” Indones. J. Electr. Electron. Eng., vol. 1, no. 2, pp. 13–18, 2018.

E. Harahap, A. Suryadi, R. Ridwan, D. Darmawan, and R. Ceha, “Efektifitas Load Balancing Dalam Mengatasi Kemacetan Lalu Lintas,” J. Mat. Univ. Islam Bandung, vol. 16, no. 2, pp. 1–7, 2017.

F. Kurniawan, “IMPLEMENTASI MODEL SIMULASI SISTEM DINAMIS TERHADAP ANALISIS KEMACETAN LALU LINTAS DIKAWASAN PINTU MASUK PELABUHAN TANJUNG,” J. Penelit. Transp. Darat, vol. 20, no. 1, pp. 1–8, 2018.

S. H. K. Pasaribu and A. Dharmawan, “Rancang Bangun Sinkronisasi Pewaktuan Lampu Lalu Lintas Menggunakan PLC Omron CPM2A Dan Wonderware Intouch,” EKSPLORA Inform., vol. 4, no. 1, pp. 93–104, 2014.

P. Gunoto, M. Irsyam, and T. K. Wijaya, “Pengembangan Sistem Traffic Lights Berdasarkan Kepadatan Kendaraan Menggunakan PLC,” J. Dimens. Univ. Riau Kepul., vol. 4, no. 3, pp. 1–12, 2015.

K. JORDAN, “MINIATUR PENGENDALI LAMPU LALU LINTAS BERDASARKAN PANJANG ANTRIAN KENDARAAN BERBASIS PROGRAMMABLE LOGIC CONTROLLER (PLC),” 2018.

D. Antono, “Lampu Pengatur Rambu Lalu Lintas Portable dengan Menggunakan Kendali Logika Terprogram,” J. Tek. Elektro Politek. Negeri Semarang, 2016.

T. Dwinugroho and P. UPY, “PERANCANGAN PROGRAM DAN SIMULASI SMART TRAFFICLIGHT MENGGUNAKAN PROGRAMMABLE LOGIC CONTROL (PLC),” 2017.

D. Hendarto and I. S. Hidayat, “PROTOTYPE SISTEM TRAFFIC LIGHT SIMPANG EMPAT DENGAN KONTROL JARAK ANTRIAN KENDARAAN BERBASIS PLC,” J. Tek. Elektro Sains JUTEK Univ. Ibn Khaldun, vol. 3, no. 1, pp. 1–9, 2016.




DOI: https://doi.org/10.32487/jtt.v7i1.577

Refbacks

  • There are currently no refbacks.


JTT (Jurnal Teknologi Terpadu) has been indexed by:

 

 

Web
Analytics

JTT Visitor Stats